must be complied with.
The warranty shall be voided if you cause defects to the device by
installing or exchanging system extensions.
The LPR 1 DHP station must not be opened except for installation and
mounting. The LPR 1DHP station contains no serviceable components.
When opening, ensure that no fluid gets into the housing. When sealing
the station, ensure that the seal is included in the rear element and that
the LPR 1 DHP station is completely closed. Otherwise, moisture can
penetrate the station and damage it.
In order to install the LPR 1DHP station, the rear element must be
detached from the front element. Refer also to the instructions on
installing the station.
The printed circuit board stack connected to the front element does not
require user service and must remain attached to the front element.
Please take note of the safety and operating instructions in the
operating instructions for the system in which you want to install the
component.
1.9 Important Information to User
Any change or modification not expressly approved by the party
rsponsible for compliance could void the user's authority to operate the
equipment.
To Next Page
Loading...
Need help?
General
