SYMEO LPR-1DHP User Manual

SYMEO Local Positioning Radar System
LPR-1DHP
Product Documentation
Web Server for LPR-1DHP units with TCP/IP interface
Copyright © Symeo GmbH 2012
Page 29 of 40
0x3 Rev. D0
0x4 Rev. D1
0x5 Rev. E0
0x6 Rev. E1
0x7 Rev. E2
7.4 Diagnostics
Connections: State of the active and inactive
connection to the LPR-1DHP station
Partitions: Size and name of available
partition of non-volatile memory.
The size of receive buffer (Recv-Q) and send buffer (Send-Q) should be
zero if possible. A long lasting value grater zero means problems when
receiving or sending data. This happens if the data cannot be readout fast
enough.
Example 1 – waiting for incoming connection:
Proto
Recv-Q
Send-Q
Local-
Address
Foreign
Address
State
tcp
0
0
0.0.0.0:3045
0.0.0.0:*
LISTEN
If Connection Type „TCP - Listening on Data Port“ (ttyS2) is enabled this table shows further
connection information.
Proto: Protocol (TCP, UDP)
Recv-Q: Number of buffered Bytes, which are received from the LPR-1DHP station
Send-Q: Number of buffered Bytes, which the LPR-1DHP station should send
Local-Address: LPR-1DHP Interface address (0.0.0.0 – listening to all interfaces)
Foreign Address: IP-address of opposite station
State: Status of connection

SYMEO LPR-1DHP Specifications

General

Brand	SYMEO
Model	LPR-1DHP
Category	Accessories
Language	English