Systec D-45 - Page 34

V/D S ERIES
M ECHANICAL ASSEMBLIES
3-6 Revision: 2.1
Fig. 26: Loosening the fastening screws on the control unit
(V series) ................................................................................ 50
Fig. 27: Loosening the fastening screws on the control unit
(D series) ................................................................................ 50
Fig. 28: Loosening the fixing nut to remove the baffle ......................... 52
Fig. 29: Levering off the fan wheel ....................................................... 52
Fig. 30: Components on the “Cooling” assembly ................................. 53
Fig. 31: Filling the closed cooling circuit............................................... 56
Fig. 32: Position of the high and low electrodes ................................... 59
Fig. 33: Steam generator: Large and small heating element
with immersion sleeve for safety temperature limiter .............. 65
Fig. 34: Position of the air compressor................................................. 68
Fig. 35: Pneumatic assembly: Position on pipe connection diagram ... 69
Fig. 36: Pneumatic assembly ............................................................... 69
Fig. 37: Closing the release openings .................................................. 70
Fig. 38: Stopping the air supply behind Y13 ........................................ 71
Fig. 39: Stopping the air supply behind Y10b ...................................... 72
Fig. 40: Stopping the air supply behind Y11/Y8 ................................... 73
Fig. 41: Position of the vacuum unit ..................................................... 74
Fig. 42: Drain cooling: Position on pipe connection diagram ............... 79
Fig. 43: Filter replacement message .................................................... 81
Fig. 44: Filter replacement: Unscrewing the screws ............................ 82
Fig. 45: Filter replacement: Removing the exhaust filter cartridge ....... 82
Fig. 46: Filter replacement: Inserting the new filter cartridge ............... 82
Tables
Tab. 1: V-40, V-55: Position in layout diagram .................................. 11
Tab. 2: V-65 – 150: Position in layout diagram ................................. 13
Tab. 3: D-23: Position in layout diagram ........................................... 15
Tab. 4: D-45: Position in layout diagram ........................................... 17
Tab. 5: D-65 – 200: Position in layout diagram ................................. 19
Tab. 6: DX-2D: Position in layout diagram ........................................ 21