Systema Eolo 20AE Series - 4 Installation; Place of Installation and Safety Distances

Gas airtight suspended warm air heaters - EOLO
19
SYSTEMA S.p.A.
Rev. 10EE0112
Fig.11b
Fig.11a
Fig.11c
Fig.11d
Fig.11e
4 INSTALLATION
4.1 Place of installation and safety distances
To obtain the maximum yield from EOLO suspended warm air heaters the following rules should be followed:
- Establish the position, bearing in mind the type of work, priority zones to be heated and absorbing walls
(windows, doors, entrances etc.) see fig. (11a, 11b, 11c).
- Install the appliances respecting the correct
distances from the walls see. fig. ( 11d,11e)
- Install the EOLO suspended heaters as near
as possible to the zone to be heated comply-
ing with a distance from the floor and from
people to ensure the jet of warm air is not
aimed directly at them.
- When positioning the EOLO suspended
heaters take into account any obstacles, such
as shelves, walls, columns, etc..
- If several appliances are to be installed in the
same environment, it is advisable to position
these on opposite walls and between one
another to cover the area to be heated
uniformly.
- If there are any drafts of cold air from
entrances, doors, etc., it is advisable to install
the appliances so that the jet of hot air is aimed
towards the source of cold air.
- Appliances must never be installed in niches
or positions that do not guarantee sufficient
aeration for correct operation.
- Several appliances installed in the same room
or in directly communicating rooms, are
considered as a single system, with a thermal
capacity of the total of the thermal capacities
of each single appliance.
- In environments subjected to vacuum
pressures or in which processes develop a
noteworthy amount of non-combustible dust,
the appliances must be installed so that air
suction and discharge of fumes is performed
directly from the outside through the outside
wall (or aperture) of the room in which the
appliances are installed.
- Installation must be performed by
professionally qualified personnel responsible
for complying with the current safety
standards. The manufacturer declines all re-
sponsibility in the case of damages caused
by erroneous installation or improper and/or incorrect use of the appliance.
N.B. Make sure that rooms are specifically ventilated for type B applications