Gas airtight suspended warm air heaters - EOLO
5
SYSTEMA S.p.A.
Rev. 10EE0112
1 GENERAL RULES
This instruction manual is an integral and essential part of the appliance and must be kept carefully
beside the appliance for further consultation.
Read the instructions and warnings contained in this manual carefully as they provide important
information on safety, installation, use and maintenance.
IMPORTANT !!
In the event of this manual being misplaced contact the manufacturer immediately.
Several appliances installed in the same room or in directly communicating rooms, are considered as
a single system, with a thermal capacity of the total of the thermal capacities of each single appliance.
Their use is not permitted to heat rooms destined for handicraft or industrial activities in which processes
and materials stored may cause the formation of gas, vapours or powders susceptible to induce fires
or explosions.
Installation must be performed by professionally qualified personnel responsible for compliance with
the current safety standards. The manufacturer declines all responsibility in the event of damages
caused by erroneous installation or improper and/or incorrect use of the appliance.
The packaging materials (nylon, foamed polystyrene, wood, staples, etc.) must not be left within the
reach of children as they are potential sources of danger.
Initial ignition of the appliance must be performed by qualified personnel.
In the case of the appliance shutting down or functioning incorrectly it must be switched off. Any
repairs or replacement of spare parts must be performed solely by qualified personnel using exclusively
original spare parts. Non-compliance with the aforesaid rules may endanger the safety of the appliance.
To guarantee correct operation of the appliance it is fundamental to carefully follow the instructions
provided by the manufacturer and to have the appliance serviced by qualified personnel at least once
a year.
N.B. To switch off the appliance always used the ambient thermostat and not the master switch on the
control board on the ground, as this could cause overheating in the combustion chamber with
consequent damage to the appliance.
The heater may be installed outdoors with temperatures down to -15°C. Below this temperature operation
of the appliance is no longer guaranteed.
2 PACKAGING
2.1 List of packing
a) The appliance complete with all its parts is delivered packed and wrapped in a protective nylon film
inside which the following are also found: the wall-mounting brackets, the electric control board
with relevant thermostat with probe (if requested) and two air/fume terminations (if requested).
To Next Page
Loading...