SystemAir SysAqua Series User Manual

English
1/4
Access
Services
Commissioning
Status
Main Menu
1/4
Access
Services
Commissioning
Status
Main Menu
1/12
10:40:05
Versions
Calendar
Limited capacity
Reduced mode
Water Law
Auto change over
Glycol protection
Communications
Language selection
03.02.2016
Cold OAT protection
Small volume protection
Commissioning
1/12
10:40:05
Versions
Calendar
Limited capacity
Reduced mode
Water Law
Auto change over
Glycol protection
Communications
Language selection
03.02.2016
Cold OAT protection
Small volume protection
Commissioning
1/1
50 %Low load lim.
Limited capacity
100
0
50
1/4
Access
Services
Commissioning
Status
Main Menu
1/4
Access
Services
Commissioning
Status
Main Menu
1/12
10:40:05
Versions
Calendar
Limited capacity
Reduced mode
Water Law
Auto change over
Glycol protection
Communications
Language selection
03.02.2016
Cold OAT protection
Small volume protection
Commissioning
1/12
10:40:05
Versions
Calendar
Limited capacity
Reduced mode
Water Law
Auto change over
Glycol protection
Communications
Language selection
03.02.2016
Cold OAT protection
Small volume protection
Commissioning
1/14
2.0 bar
2.0 bar
3.0K
3.0K
2.0K
-P. cond. delta
-P. evp. delta
-Circuit 1
Low noise
-Water t.eco sh.H
-Water t.eco sh.C
Eco mode
-Wat.t.night sh.C
Decreased cool. setp
Decreased cool. setp
Reduced mode type
Reduced mode
1/4
Eco+low noise
Low noise
Eco
Decreased cool. setp
33SysAqua
13.4.8. REDUCED MODE
13.4.9. LIMITED CAPACITY
The "reduced mode" mode activation can be triggered in the following ways:
² directly on the SysAqua via the user interface
² communication network (Modbus/Bacnet/Cloud)
² external dry contact D2 if entry congured.
Limited capacity is occasionally used to limit the electricity consumption of the SysAqua to prevent exceeding
the electric power capacity of the installation site.
The "Limited capacity" mode activation
can be triggered in the following ways:
² directly on the SysAqua via the
user interface
² communication network (Modbus/Bacnet/Cloud)
² external dry contact D2 if entry congured.
Reduced mode can have the following
congurations:
² Decreased cool. setp
This function is only available if
the unit is in cool mode. It can cool the building at night
when electricity is less expensive.
² Eco
Heat and cool setpoints are respectively lowered and raised to reduce the unit's electrical
consumption.
² Low noise
In cool mode, the condensation pressure setpoint is increased to reduce the noise generated by the
ventilators.
² Eco + Low noise

SystemAir SysAqua Series Specifications

General

Brand	SystemAir
Model	SysAqua Series
Category	Chiller
Language	English