TA Instruments TGA 2050 - Page 20

Introducing the TGA 2050
1–8 TA I NSTRUMENTS TGA 2050
Table 1.1
Instrument Keypad
Function Keys
(continued)
Key/Function Explanation
STOP If an experiment is
running, this key ends the
method normally, as
though it had run to
completion; i.e., the
method-end conditions go
into effect, and the data
that has been generated is
saved. This is the same
function as Stop on the
controller.
If an experiment is not
running (the instrument is
in a stand-by or method-
end state), the STOP key
will halt any activity (air
cool, all mechanical
motion, etc.).