TA I
NSTRUMENTS
TGA 2050 3–21
Stopping an
Experiment
If for some reason you need to discontinue the
experiment, you can stop it at any point by using
either the STOP key on the TGA instrument
keypad or Stop on the controller screen. Another
function that stops the experiment is Reject on
the controller. However, the Reject function
discards all of the data from the experiment; the
Stop function saves any data collected up to the
point at which the experiment was stopped.
The Heat Exchanger will continue to run as long as
the Air Cool option is activated or until the indi-
cated temperature is below 50
o
C.
The REJECT function discards all experiment
data.
Running an Experiment
NOTE:
t
CAUTION:
To Next Page
Loading...
