Tabor 8020 - Page 10

5-10-7 Sine Flatness 5-6
5-10-8 Trigger, Gate, Manual 5-6
5-10-9 Sweep 5-6
5-10-10 VCO Control 5-7
5-10-11 Pulse Width (model 8021) 5-7
5-10-12 Amplitude Modulation (model 8022) 5-8
SECTION 6. THEORY OF OPERATION
6-1 Introduction 6-1
6-2 Overall Functional Description 6-1
6-3 Analog Circuitry 6-1
6-3-1 Current Generator 6-1
6-3-2 Voltage controlled Oscillator 6-3
6-3-3 Sine Shaper 6-4
6-3-4 Trigger Circuit 6-4
6-3-5 Pulse Shaper 6-6
6-3-6 Preamplifier 6-7
6-3-7 Attenuator 6-7
6-3-8 Offset Generator 6-7
6-3-9 Power Amplifier 6-7
6-3-10 Post Amplifier Attenuator 6-7
6-3-11 Power Supply 6-7
6-4 Pulse Generator Circuit (model 8021) 6-7
6-5 AM Circuit (model 8022) 6-9
6-6 Digital Circuitry 6-9
6-6-1 Display and Keyboard Interface 6-9
6-6-2 Counter Circuit 6-10
6-6-3 IEEE-488 Interface (Option 1) 6-10
SECTION 7. ADJUSTMENTS
7-1 Introduction 7-1
7-2 Adjustments 7-1
7-2-1 Environmental Conditions 7-1
7-2-2 Warm-up Period 7-1
7-2-3 Recommended Test Equipment 7-1
7-2-4 Adjustment Procedures 7-1
7-3 Adjustment Procedure 7-2
7-3-1 Power Supply Adjustment 7-2
7-3-2 Distortion Adjustment 7-2
7-3-3 Frequency Adjustment 7-2
7-3-4 Low Frequency Adjustment 7-2
7-3-5 Low Frequency Distortion Adjustment 7-2
Model 8020 Table of Contents
Page -5