7-3-6 Trigger Start Phase Adjustment 7-3
7-3-7 Amplitude Adjustment 7-3
7-3-8 Offset Adjustment 7-3
7-3-9 Squarewave Response Adjustment 7-3
7-3-10 Sine Flatness Adjustment 7-3
7-3-11 Triangle Flatness Adjustment 7-4
7-3-12 Reference Oscillator Adjustment 7-4
7-3-13 Pulse Width Adjustment (model 8021 only) 7-4
7-3-14 Ramp Amplitude Adjustment (model 8021 only) 7-4
7-3-15 Amplitude Modulation Adjustment 7-4
SECTION 8. PARTS LIST
8-1 General 8-1
8-2 Ordering Information 8-1
8-3 Maintenance Kit 8-1
8-4 Parts Description 8-1
SECTION 9. SCHEMATIC DIAGRAMS
LIST OF TABLES
1-1 Model 8020 Specifications 1-3
3-1 Default State After Software Reset 3-5
3-2 Offset Amplitude Programming Limits 3-7
3-3 Front Panel Parameter Entry Limits 3-8
4-1 Model 8020 Interface Function Codes 4-4
4-2 IEEE contact Designation 4-5
4-3 IEEE-488 Bus Command Summary 4-6
4-4 Default conditions. (Status after SDC or DCL) 4-8
4-5 Device Dependent Command Summary 4-10
4-6 SRQ Mask Commands 4-13
4-7 SRQ Mask Legal Commands 4-13
5-1 Line Fuse Selection 5-1
5-2 Required Test Equipment 5-4
8-1 Model 8020 Parts List - Main Board assembly 8-1
8-2 Model 8020 Parts List - Final Amplifier Board Assembly 8-4
8-3 Model 8020 Parts List - Front Panel Board Assembly 8-7
8-4 Model 8021 Parts List - Pulse Generator Board Assembly 8-7
8-5 Model 8022 Parts List - AM Generator Board Assembly 8-8
Model 8020 Table of Contents
Page -6
To Next Page
Loading...