Tabor 8020 - Page 7

3-3 Rear Panel Familiarization 3-4
3-3-1 Connectors and Switches 3-4
3-4 Power-up Procedure 3-4
3-5 Software Reset 3-5
3-5-1 Parameter Preset 3-5
3-6 Display Messages 3-6
3-7 Detecting Programming Errors 3-6
3-7-1 General Error 3-6
3-7-2 Pulse/Ramp Set-up Errors (model 8021 only) 3-6
3-7-3 Offset Errors 3-6
3-7-4 IEEE-488 Errors 3-7
3-8 Selecting 2nd Functions 3-7
3-9 Modifying Parameters 3-7
3-9-1 Modifier 3-8
3-9-2 Range 3-8
3-9-3 Parameter Limits 3-8
3-10 Selecting an Output Waveform 3-9
3-11 Disabling The Output 3-9
3-12 Selecting an Operating Mode 3-9
3-12-1 Function Generator Mode 3-9
3-12-2 Sweep Generator Mode 3-9
3-12-2-1 Selecting Sweep Direction 3-9
3-12-3 Voltage Controlled Oscillator Mode 3-10
3-12-4 Pulse Generator Mode (model 8021 only) 3-10
3-12-5 AM Mode (model 8022 only) 3-11
3-13 Triggering The Pulse Generator 3-11
3-14 Using Front Panel Set-ups 3-11
3-14-1 Store Set-ups 3-11
3-14-2 Recall Set-ups 3-12
3-14-2-1 Using The Recall Mode 3-12
3-15 Using The Offset 3-12
3-16 Changing The GPIB Address 3-12
SECTION 4. IEEE PROGRAMMING
4-1 Introduction 4-1
4-2 Bus Description 4-1
4-3 IEEE-488 Bus Lines 4-2
4-3-1 Bus Managment Lines 4-2
4-3-2 Handshake Lines 4-2
4-3-3 Data Lines 4-3
4-4 Interface Function Codes 4-3
4-5 Software Considerations 4-4
4-6 Hardware Consideration 4-4
Model 8020 Table of Contents
Page -2