EasyManuals Logo

Tait TP9400 Series P25 User Manual

Tait TP9400 Series P25
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #147 background imageLoading...
Page #147 background image
Charging and caring for batteries 147
Charger for IS batteries only
Notice Placing a fully charged battery into the
charger for IS batteries may result in both the orange
and red LED lighting up. In this case, remove the
battery and use as normal. Leaving the battery in the
charger may result in the battery being discharged.
Vehicle charger only
It is safe to switch off the ignition while there is still a
battery in the charger. However, if the vehicle will not
be used again for some time, check whether charging
will continue while the ignition is off, and consider
what effect this might have on the vehicle battery.
To check, place the battery in the charger, and switch
off the vehicle ignition:
If no charger LED stays lit, the charger will resume
charging only when the ignition is switched on
again. Minimal charger standby power will be
drawn from the vehicle battery until then.
If a charger LED stays lit, the charger will continue
to charge the radio battery even while the ignition
is off, and will continue to draw power from the
vehicle battery. Once the battery is charged, the
charger draws minimal current and has little effect
on a healthy vehicle battery.
Receiving calls while charging
Applies to desktop charger and multicharger
only.
Notice For best charging performance, switch off the
radio before placing it in the charger.
You can receive a call while the radio is in the charger,
but your radio performance may be degraded. If you
do remove the radio from the charger to answer a call,
the call will not be disrupted.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tait TP9400 Series P25 and is the answer not in the manual?

Tait TP9400 Series P25 Specifications

General IconGeneral
P25 PhasePhase 1 and Phase 2
Frequency BandsVHF: 136-174 MHz, UHF: 380-520 MHz, 700/800 MHz: 764-870 MHz
Operating Temperature-30°C to +60°C (-22°F to +140°F)
Operating Voltage7.4V DC (Nominal)
MIL-STDMIL-STD-810 C/D/E/F/G
Battery LifeUp to 12 hours (depending on usage)

Related product manuals