Tait TP9400 Series P25 User Manual

62 Operating in conventional mode
Making a call
To make a call:
1 Select the required zone (see "Selecting a zone"
on page 56).
2 Select the required channel (see "Selecting a
channel" on page 57).
3 Hold the radio so that the microphone is about
one inch (2.5 cm) from your mouth and press the
PTT key to transmit.
If the channel is busy, you may not be able to
transmit. Wait until the status LED has stopped
glowing green, and then try again.
4 Speak clearly into the microphone and release the
PTT key when you have finished talking.
While you are transmitting the LED glows red and
appears on the display.
5 Finish your conversation as soon as possible and
release the PTT key. For a short time, your radio
may prevent you from making another call.
Making an individual call
This feature is available for digital channels only.
For analog individiual calls, see "Making a local call"
on page 65.
To make a call to one person rather than a group of
people:
1 Press Menu and select Individual call.
(The person to whom you last made an individual
call is highlighted.)
Channel 1
Zone 11
MenuCancel

Tait TP9400 Series P25 Specifications

General

P25 Phase	Phase 1 and Phase 2
Frequency Bands	VHF: 136-174 MHz, UHF: 380-520 MHz, 700/800 MHz: 764-870 MHz
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Operating Voltage	7.4V DC (Nominal)
MIL-STD	MIL-STD-810 C/D/E/F/G
Battery Life	Up to 12 hours (depending on usage)