EasyManuals Logo

Tait TP9400 Series P25 User Manual

Tait TP9400 Series P25
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30 Before using your radio
2 Before using your radio
Once you have unpacked your radio, there are a few
tasks you must do before you can use it. The most
important of these is to charge your battery for the first
time allow 2.5 hours for this.
Warning Use only a Tait-supplied, IS-approved
battery, charger, antenna, audio accessory, carry
accessory or programming adapter with an IS radio.
Fitting a battery or accessory that is not IS-approved,
using a charger that is not IS-approved, or failing to
use the IS programming adapter, creates a risk of
explosion which could cause serious injury or death.
For an up-to-date list of approved accessories,
contact your regional Tait office. For detailed
information about IS radios and how to identify them,
see "Intrinsically Safe radios and accessories" on
page 10.
Warning Do not charge the battery or change the
antenna in a hazardous location. An explosion could
cause serious injury or death.
This section covers:
For your safety battery warning
Attaching labels to the radio or battery
Charging the battery before first use
Attaching the battery
Removing the battery
Attaching the antenna
Removing the antenna
Attaching a belt clip
Removing a belt clip
Installing an audio accessory

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tait TP9400 Series P25 and is the answer not in the manual?

Tait TP9400 Series P25 Specifications

General IconGeneral
P25 PhasePhase 1 and Phase 2
Frequency BandsVHF: 136-174 MHz, UHF: 380-520 MHz, 700/800 MHz: 764-870 MHz
Operating Temperature-30°C to +60°C (-22°F to +140°F)
Operating Voltage7.4V DC (Nominal)
MIL-STDMIL-STD-810 C/D/E/F/G
Battery LifeUp to 12 hours (depending on usage)

Related product manuals