Tait TP9400 Series P25 User Manual

Before using your radio 35
Installing an audio accessory
Warning Use only Tait-supplied, IS-approved audio
accessories with IS radios. Fitting an audio accessory
that is not IS-approved exposes the customer to a risk
of explosion which could cause serious injury or
death. For an up-to-date list of approved audio
accessories, contact your regional Tait office.
For detailed information about IS radios and how to
identify them, see "Intrinsically Safe radios and
accessories" on page 10.
Audio accessories plug into the radio’s accessory
connector. The accessory connector is protected by a
cover, which needs to be removed before an
accessory can be installed.
Notice The accessory cover protects the accessory
connector from electrostatic discharge. Keep the
cover in place unless the connector is in use.
To remove the accessory cover and install an audio
accessory:
1 Use a coin or other blunt object to loosen the screw
that secures the accessory cover to the radio.
2 Remove the accessory cover and store it in a safe
place.
3 Plug the accessory into the accessory connector.
4 Tighten the screw.

Tait TP9400 Series P25 Specifications

General

P25 Phase	Phase 1 and Phase 2
Frequency Bands	VHF: 136-174 MHz, UHF: 380-520 MHz, 700/800 MHz: 764-870 MHz
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Operating Voltage	7.4V DC (Nominal)
MIL-STD	MIL-STD-810 C/D/E/F/G
Battery Life	Up to 12 hours (depending on usage)