Tait TP9400 Series P25 User Manual

84 Operating in P25 trunking mode
Unconnected calls
If your call is not connected, the way your radio
behaves is explained in the following table.
Radio behavior Explanation
The system is too busy to process your
talkgroup or individual call.
The radio sounds three
short beeps.
The system is now available to process your
talkgroup or individual call.
The radio sounds five
beeps, followed by a
repeating double beep.
You have selected a talkgroup that does not
currently exist on the system. Your display
shows that you have lost service and no
longer appears.
See "Service is lost" on page 77.
The radio sounds two
short beeps.
You have attempted to make an individual
call to a radio that does not currently exist
on the system.
You have attempted to make an individual or
phone call, but you are not authorized to do
this.
The radio sounds two
short beeps.
Your individual or phone call has been
rejected or is unanswered.
System
queued
Busy channel
now free
Talkgroup 1
No service
Menu
No answer
No answer

Tait TP9400 Series P25 Specifications

General

P25 Phase	Phase 1 and Phase 2
Frequency Bands	VHF: 136-174 MHz, UHF: 380-520 MHz, 700/800 MHz: 764-870 MHz
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Operating Voltage	7.4V DC (Nominal)
MIL-STD	MIL-STD-810 C/D/E/F/G
Battery Life	Up to 12 hours (depending on usage)