3-28
OPERATION
PARKING THE MACHINE
PARKING
WARNING
• Park the machine on a flat, rigid and
safe ground. Set the parking brake.
If you must park on a slope or incline,
park the machine securely and block
the movement of the machine.
• When parking on a street, use barriers,
caution signs, lights, etc., so that the
machine can easily be seen even at
night to avoid collision with other
vehicles.
• Before leaving the operator’s seat, raise
the safety lock lever to engage the lock
and stop the engine. Also, be sure to
remove the key, lock the door and
covers, take it with you and store it in a
specified place.
1. Set the left and right travel levers to the
neutral position.
2. Return the throttle lever to idle the engine
at low speed.
3. Lower the bucket and the dozer blade to
the ground.
4. Raise the safety lock lever to the locked
position.
5. Lock the dozer blade lever and the offset
pedal.
6. Stop the engine and remove the key.
Refer to “Stopping the engine” on page 3-
5.
PARKING THE MACHINE
INSPECTION AND CHECKS AFTER
STOPPING THE ENGINE
1. Check for oil or water leak and inspect the
working equipment, covers and
undercarriage. If any irregularities are
found, repair.
2. Fill up the fuel tank.
Refer to “Inspecting the fuel level” on page
5-18.
3. Remove any paper scraps or dirt from the
engine room.
4. Remove any mud from the undercarriage.
Locking
Be sure to lock the following places:
• Fuel filler cap
• Cab door
• Manual storage compartment
• Engine hood
• Covers
To Next Page
Loading...
Need help?
General
