2-19
CONTROLS
LEVERS AND PEDALS
SAFETY LOCK LEVER
WARNING
• Before standing up from the operator’s
seat to open/close the window or
remove/install the lower window, lower
the working equipment to the ground,
raise the safety lock lever to engage the
lock and stop the engine. If any controls
should be accidentally touched when
the safety lock lever is lowered
(unlocked), the machine will suddenly
move and cause serious injury or death.
• Note that the dozer blade control
cannot be locked, even when the safety
lock lever is set to the lock position.
Do not carelessly touch this control.
• Be careful not to touch the operating
levers when raising or lowering the
safety lock lever.
• Before leaving the operator’s seat, lower
the working equipment to the ground,
raise the safety lock lever to engage the
lock and stop the engine. Also, be sure
to remove the key, lock the door and
covers, take it with you and store it in a
specified place.
THROTTLE LEVER
This controls the engine speed.
(A) .......Low idling
(B) ......Maximum speed
This device is for locking the hoe attachment,
auxiliary hydraulic circuits, slewing and
traveling.
When the lever is raised, the lever stand
springs up and the controls are locked.
LEVERS AND PEDALS
To Next Page
Loading...
