Lubricant
Location Type
Type by air temperature
When to replace
-4 14 32 50 68 86 104°F
-20 -10 0 10 20 30 40°C
Engine oil pan
Diesel engine oil
API: CF class or higher
Every 250 hrs.
after the initial
50 hrs.
Hydraulic oil
tank
Diesel engine oil
API: CF class
Every 1000 hrs.
Engine cooling
system
Cooling water (water +
coolant)**
SAE: J814C, J1941,
J1034 or J2036
ASTM: D6210 or
D4985 (USA)
Every 1000 hrs.
T
ravel reduction
gear
Gear oil
API: GL-4
SAE 90
Every 500 hrs
after the initial
250 hrs*.
W
orking
equipment
Lithium based gr
ease
EP-2
NLGI No.2
—
Daily or every
10 hrs.
Levers When r
equired
SERVICE DATA
Mixture of 50% coolant
Mixture of 30% coolant
SAE 10W-30
SAE 10W-30
* : If the ratio of traveling time to total operating time is high, replace the gear oil earlier than
the specified time.
** : For water, use tap water (soft). Do not use well or river water. When the ambient
temperature drops below 0°C (32°F), add coolant (antifreeze). Follow the coolant
manufacturer’s instructions to determine the mixture ratio.
To Next Page
Loading...
