IF A FUSE BLOWS
If a light does not come on or the electrical
system does not work, a fuse may be blown.
Inspect the fuses.
INSPECTING AND REPLACING THE FUSE
WARNING
If the fuse blows again soon after
replacement, then the electric system is
likely faulty. It may pose a fire hazard if
not properly repaired. Contact your sales
or service dealer for advice.
1.
Turn the ignition key to the OFF position
and stop the engine.
IF A FUSE BLOWS
2. Loosen the screw and remove the fuse
box cover (1).
3.
Check for any blown fuses.
4. If a fuse is blown, replace it with a spare
fuse of the same capacity.
Fuse layout and cir
cuits protected
Capacity
Protected
circuit
Capacity
Protected
circuit
20A Fr
ont lights
20A T
ail lights
10A
Fr
ont wiper
(Option)
5A
Instrument
cluster
10A
Rear wiper
(Option)
20A
Radio
(ACC),
Reserved
15A Solenoid 10A
Contr
oller
(Backup)
10A
Contr
oller
(ACC)
5A
Immobilizer
(Backup)
10A
Stop
solenoid
10A Horn
5A Feed pump 10A
Interior light,
Radio
(Backup)
10A
Lever lock,
Generator
10A Contr
oller
5A
Immobilizer
(ACC)
20A Optional
To Next Page
Loading...
