ERROR CODE LIST
On the multi-data display, five error codes are displayed (the leftmost code is the most recent
error). If an error code appears on the multi-data display, inform your sales or service dealer of
the code and ask for help.
Error code Error details
01
Repeated short-time operations (0.5 seconds or less) of the key
switch are
recorded.
02
After the engine starts, the engine oil pressure drops below the specified level
(insufficient oil).
03 After the engine starts, the charge alter
nator fails.
04 The engine overheats (water temperatur
e is over 110°C).
06 The air cleaner is clogged.
09 Emergency r
elease signal is recorded.
11 Excess ignition time (15 seconds or mor
e) of the glow plug is recorded.
12 The battery voltage is too high (above 24 V for 1 second or mor
e).
13 The battery voltage is too low (below 7 V for 1 second or mor
e).
14 The emergency r
elease signal is changed from ON to OFF.
15
The r
eal-time clock is faulty. Reset operation is recorded. The battery voltage
drops for too long, and the time function is reset.
16
When the ignition switch is tur
ned on, the engine oil pressure sensor fails (line
break).
17
When the ignition switch is turned on, the charge signal is in the ON (24V) state
(charge warning lamp is not lit).
ERROR CODE LIST
To Next Page
Loading...
Need help?
General
