22
Menu Description
Number Menu Sub-menu (Options)
DTMFST27
The device emits the tone sound when keypad tones are used during transmission.
The device emits the tone sound during automatic ID transmission.
The device emits the tone sound for both keypad and automatic ID transmissions.
No sidetone is emitted for keypad tones during transmission.
PTT + ID
ID
Side-tone
OFF
28 Plays a specific tone when Side Key 3 is pressed while pressing PTT.TONE
1000hz
1450hz
1750hz
2100hz
PTT-
LT
29
Delay time before automatic encoding.
0Ms、100Ms、200Ms
400Ms、600Ms
800Ms、1000Ms
VOX30
Turn off voice-operated transmission (VOX).
VOX
DELAY
31
From 0.5 to 2.0, with 0.1 increments as options.
Activate voice control sensitivity, where level 1 is the most sensitive and level 9
is the least sensitive.
OFF
Level 1-9
0.5sec~2.0sec
Turn off encryption to ensure compatibility with standard analog systems.
Activate frequency hopping with the option to select an encryption group. Only
devices with matching encryption groups can communicate. Once enabled,
accessing repeaters is not possible.
Encryption 1,
Encryption 2,
Encryption 3.
VOICE
-PRI
32
OFF
Disable transmission time limit.
Set the maximum transmission time when PTT is pressed.
30 sec、 60 sec、120 sec
240 sec、 480 sec
TO
T(Tim
-Out
Timer)
33
OFF
Wide
W/N34
Operate in wide band.
Operate in narrow band.Narrow
Activate busy channel lock.
Turn off busy channel lock.OFF
ON
BCL35
Release the PTT without sending a shutdown code, typically used in relay transfer
36
to produce noise, confirming if the signal from the device is being relayed.
After releasing the PTT button, the device emits a shutdown code to suppress
the momentary noise at the receiving end.
STE
OFF
ON
To Next Page
