User's Manual
7-5
Trouble-
shooting
TROUBLE-SHOOTING
Table 7.2 Paper Handling Problems and Solutions (Cont.)
Problem Solution
Paper cannot be If you are using a cut sheet feeder, make sure that the
loaded or fed. bin lever is set to the "CLOSED" position. (The bin
(continued) lever is on the left side of the feeder.)
If you are using a cut sheet feeder, open the front
cover and make sure that the third stud from the left
on the printer bottom frame projects.
Paper jams while Move the paper thickness lever to position D.
loading. Turn off the printer and remove the jammed
paper. Remove any obstructions from the paper
path.
Make sure that the paper thickness lever is set for
the thickness of your paper. See Table 3.2 in
Chapter 3.
If you are using a cut sheet feeder, make sure that the
bin lever is set to the "CLOSED" position. (The bin
lever is on the left side of the feeder.)
Make sure that the paper is not folded, creased, or
torn.
Reload the paper.
Paper jams while Move the paper thickness lever to position D.
printing. Turn off the printer and remove the jammed
paper. Remove any obstructions from the paper
path.
Make sure that the paper thickness lever is set for
the thickness of your paper. See Table 3.2 in
Chapter 3.
To Next Page
Loading...
