USING SETUP MODE
User's Manual5-54
Procedure
To print hex dumps, make sure that continuous forms paper is loaded into
the printer. Then proceed as follows:
1. Enter setup mode.
2. Select the HEX-DUMP function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under HEX-DUMP, then press the TEAR OFF button
or the MENU button to select the HEX-DUMP function. The
printer goes online and prints a header and a short help menu.
3. Print the hex dump.
To start hex dump printing, send your file or program to the printer.
The printer goes online and prints the hex dump.
Press the MENU button or the TEAR OFF button to pause during
hex dump printing. To resume hex dump printing, press the button
again.
NOTE
When hex dump printing stops, the printer remains online in
setup mode (the ONLINE indicator is green). To print another
hex dump, send another file to the printer.
To Next Page
