TallyGenicom 2248 - Procedure

USING SETUP MODE
User's Manual5-28
3. Select an emulation.
Repeatedly press the LOAD button or the LF/FF button to position
the cursor under the emulation you require. Then do either of the
following:
• Press the MENU button to select the emulation and print the next
MENU1 or MENU2 item. (As shown in Table 5.3, this is the
<FONT> item).
• Press the TEAR OFF button to select the emulation and print
<==END==>. Press the TEAR OFF button again to print the
last MENU1 or MENU2 item. (As shown in Table 5.3, this is
the <RGHTEND> item). The TEAR OFF button is convenient
when the options you need to change are near the end of the list of
items.
NOTE
Whenever you select a new emulation, all MENU1 or MENU2
options are reset to the factory defaults for that emulation.
Procedure
To change the options assigned to MENU1 or MENU2, make sure that
continuous forms paper is loaded and then proceed as follows:
1. Enter setup mode.
2. Select the MENU1 or MENU2 function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under either the MENU1 or MENU2 function. Press
the TEAR OFF button or the MENU button to select the function
and print the following <EMULATE> options:
<EMULATE> ESC/P2 XL24E