USING SETUP MODE
User's Manual5-4
Select Function SAVE & END Exits setup mode and saves any changes made
while in setup mode.
MENU1 and Assigns print features to MENU1 and
MENU2 MENU2 on the printer control panel.
HARDWRE Changes the printer hardware options.
ADJUST Changes the print position adjustment options.
CONFIG Changes the configuration options.
The initial printout contains a header, help menu, and <<FUNCTION>>
menu. The header tells you that the printer is offline and in setup mode. The
help menu provides a quick summary of how to use setup mode. The
<<FUNCTION>> menu lists all of the functions available to you in setup
mode. Note that the red cursor on the plastic print guide is initially positioned
below the SAVE & END function.
Setup mode can also be entered by turning off the printer, then turning the
printer back on while pressing the TEAR OFF and ONLINE buttons
simultaneously until the printer beeps.
When you enter setup mode, the following <<FUNCTION>> menu is
printed:
OVERVIEW OF SETUP
MODE
Table 5.1 summarizes the purpose of each function.
Table 5.1 Setup Mode Functions
Type Function Purpose
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
To Next Page
Loading...
