TallyGenicom 2248 - Setup Mode Example

USING SETUP MODE
User's Manual5-6
To select an option from the <item> menu:
1. Repeatedly press the LOAD button or the LF/FF button to position
the red cursor on the plastic print guide under the option you require.
2. Press the MENU button to select the option. The printer prints the
next item and its options. You can press MENU to select the option.
Then, the printer prints the previous item and its options.
3. After selecting the desired options, press the ONLINE button to
reprint the <<FUNCTION>> menu.
For each item, the short-underlined option is the current default option
(the option currently saved in the printer’s permanent memory). In
the previous example, the default options are Epson ESC/P2
emulation, Courier 10 font, and letter print quality.
The chart on the next page summarizes how to select options such as
emulation, font, and print quality and how to use functions that do not
have options.
Setup Mode Example
To become familiar with setup mode, try the following example. This example
shows how to change the font and pitch in MENU2 to Prestige Elite 12 and 12
cpi.
1. Load continuous forms paper.
2. Enter setup mode.
3. Select the MENU2 function.
Wait for the printer to stop printing and press the LOAD button or
the LF/FF button twice to position the red cursor on the print guide
under MENU2. Press the TEAR OFF button or the MENU button to
select the MENU2 function and print the <EMULATE> item and its
options.