TallyGenicom 2248 - Changing Print Position Adjustment Options

USING SETUP MODE
User's Manual5-36
When you print using ruled paper, you often want to adjust the print
position so that the print sits properly on the ruled lines. The ADJUST
function allows you to:
• Set top-of-form position
• Fine-tune top-of-form position
• Fine-tune left print start column (left margin)
• Adjust for accumlative line spacing error in a page
The first three items are provided separately for cut single sheets and
continuous forms. The last item is available for single sheets only.
The top edge of your paper is the physical top of the page. The logical top
of the page, as “understood” by the printer when loading paper, is called the
top-of-form. Printing starts at this position. Note that printing actually
starts at the position obtained by adding the following:
• Top-of-form, default = 1.8/6 inch (7.6mm)
• Top margin specified by your software
• Printer TOP-MRG (top margin setting), default = 1 line
Table 5.5 describes the ADJUT items and options. Items are listed in the
order they are printed. The procedure for changing top-of-form is described
after Table 5.5.
CHANGING PRINT
POSITION ADJUSTMENT
OPTIONS