Important Information
This equipment generates and uses radio frequency
energy and if not in-stalled and used properly, that is, in
accordance with the manufacturer’s in-structions, may
cause interference in radio and television reception. It
has been type tested and found to comply with the limits
for class B computing devices in accordance with the
specification in subpart J of part 15 of FCC rules, which
are designed to provide reasonable protection against
such interference in a residential installation. However,
there is no guarantee that interference will not occur in a
partial installation. If this equipment does cause
interference to radio or television reception, which can be
de-termined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Reorient the receiving antenna,
Relocate the peripheral away from the receiver,
Move the peripheral away from the receiver
Plug the peripheral into a different outlet, so that the
peripheral and re-ceiver are on different branch circuits
If necessary, the user should consult the dealer or an
experienced radio/ television technician for additional
suggestions. The user may find the fol-lowing booklet,
prepared by the Federal Communications Commission,
helpful: “How to Identify and Resolve Radio-TV
Interference Problems”.
This booklet is available from the U.S. Government
Printing Office, Washington DC 20402 Stock No.
004.000.00345.4.
WARNING: To comply with FCC regulations on
electromagnetic inter-ference for a class B computing
device, the printer cable must be shielded. To assure
compliance with FCC regulations for a computing device,
use a shielded interface cable with a metal shell
connector. The use of cables not properly shielded may
result in violating FCC regulations.
This digital apparatus does not exceed the class B limits
for radio noise emissions from digital apparatus as set
out in the radio interference regu-lations of the Canadian
department of communications.
This unit complies with DOC standard C108.8-M 1983
Maschinenlärminformations-Verordnung - 3. GPSGV, der
höchste Schalldruckpegel beträgt 70 dB(A) oder weniger
gemäss EN ISO 7779
WARNING For continued protection against risk of fire, replace only with same type and rating of fuse.Only trained and
qualified personnel may open covers or remove parts that are not explicitly shown and described in the User Guide
as being accessible to the operator.
The paper used is made of raw materials treated with a
chlorine-free bleaching process.
This device fulfils the European standards requirements by complying with
the Directive of the Com-mission dated May 3, 1989 (89/336/EEC) relating
to electromagnetic compatibility and the Directive dated February 19, 1973
(73/23/EEC) relating to low-voltage electrical equipment.
Conformity with the above mentioned Directives is indicated by the CE symbol
attached to the device.
Note: Conformity may be affected by:
- using interface cables not complying with the specifications
- non-observance of important instructions in the operator’s manual
- installing components not approved for this device by the manufacturer
- unauthorized manipulation
To Next Page
Loading...
