Taylor 8756 User Manual

TROUBLESHOOTING GUIDE
8-3
Model 8756
Troubleshooting Guide
8
10. Freezing cylinder walls
are scored.
a. Broken pins on the beater
assembly.
a. Repair or replace the beater assembly.
Make sure the scraper blades are
properly seated on pins.
6-2
b. Missing front bearing. b. Install the front bearing on the back of
the freezer door.
6-3
c. The beater assembly is bent. c. Repair or replace the beater assembly.
Contact a Taylor service technician to
correct the cause of insufficient mix in
the freezing cylinder.
- - -
11. The air/mix pump does
not operate.
a. The pump motor is not activated. a. Place power switch in the OFF position.
Push the reset button on the pump drive
motor. Place the power switch in the ON
position.
- - -
b. The pressure switch diaphragm
was installed incorrectly or is
missing.
b. The diaphragm must be correctly
installed in the pressure switch cap. 6-9
c. Defective air/mix pump pressure
switch.
c. Contact a Taylor service technician to
replace the pressure switch.
- - -
12. The machine will not
operate in the Auto
mode.
a. The machine is unplugged. a. Plug the machine into the wall
receptacle.
- - -
b. The circuit breaker is off or the fuse
is blown.
b. Turn the breaker on or replace the fuse.
- - -
c. Low on mix. The MIX OUT light is
flashing.
c. Add mix to the mix tank and press the
AUTO key.
5-1
d. The mix probe is not installed
properly or is damaged.
d. Check the mix probe installation.
6-6
e. The beater motor is out on reset. e. Reset the freezer. 5-1
f. The power switch is in the OFF
position.
f. Place the power switch in the ON
position.
6-11
g. The machine is off on high head
pressure.
g. Air-cooled: clean the condenser. 
Water-cooled: check the water supply.
Contact a Taylor service technician.
7-2
13. Overrun is too low. a. The air orifice is plugged. a. Use a soap solution to clean the small
hole in the air orifice.
- - -
14. Air is popping during
the dispensing of
product.
a. Incorrect assembly of the air/mix
pump.
a. Assemble and lubricate the air/mix pump
components according to instructions.
6-6
b. The mix suction line is losing its
prime.
b. The mix suction line is cracked or has a
loose fit to the mix inlet fitting. Replace
the mix suction line.
- - -
Problem Probable Cause Remedy
Page
Ref.

Taylor 8756 Specifications

General

Brand	Taylor
Model	8756
Category	Ice Cream Maker
Language	English