EasyManuals Logo

Taylor PH61 User Manual

Taylor PH61
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
5-2
USER INTERFACE
PH61 Peristaltic Pump
User Interface
5
Power Switch
The power switch is under the control panel on the
left-hand side of the machine. When placed in the ON
position, the power switch allows Softech™ panel
operation.
Liquid Crystal Display
The Liquid Crystal Display (LCD) is on the front control
panel. The LCD shows what mode the freezer is
operating and whether or not there is sufficient mix.
Indicator Lights
MIX LOW—When the MIX LOW light begins to flash, the
mix hopper has a low supply of mix and should be refilled
as soon as possible. The word LOW will also display on
the LCD indicator next to the word MIX.
MIX OUT—When the MIX OUT light begins to flash, the
mix hopper has been almost completely exhausted and
has an insufficient supply of mix to operate the freezer.
The word OUT will also display on the LCD indicator next
to the word MIX. At this time, the Auto mode is locked out
and the freezer will be placed in the Standby mode. To
initiate the refrigeration system, add mix to the mix
hopper and press the AUTO key. The freezer will
automatically begin operation.
HEAT MODE—When the HEAT MODE light is flashing,
the freezer is in the process of a Heat cycle.
CLEAN MANUALLY—When the CLEAN MANUALLY
light is flashing, the machine must be disassembled and
brush-cleaned within 24 hours.
When all four indicator lights are flashing, this signifies a
locked condition. Once a hard lock condition has been
remedied, two lights will remain flashing until the MIX
LOW and MIX OUT conditions have been satisfied.
During a soft lock condition, all four lights will stop
flashing once the machine has been placed in a Heat
cycle.
Reset Mechanism
The RESET button is in the right-side panel. The reset
mechanism protects the beater motor from overloading.
Should an overload occur, the reset mechanism will trip.
To properly reset the freezer, place the power switch in
the OFF position. Press the RESET button firmly. Turn
the power switch to the ON position. Clear the fault.
Press the WASH key and observe the freezer's
performance. Open the side access panel to check if the
beater motor is turning the driveshaft in a clockwise (from
the operator end) direction without binding.
DANGER! DO NOT use metal objects to press
the RESET button. Failure to comply may result in severe
personal injury or death.
If the beater motor is turning properly, press the WASH
key to cancel the cycle. Press the AUTO key to resume
normal operation. If the machine shuts down again,
contact a Taylor service technician.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taylor PH61 and is the answer not in the manual?

Taylor PH61 Specifications

General IconGeneral
BrandTaylor
ModelPH61
CategoryFreezer
LanguageEnglish

Related product manuals