Taylor Wawa C708 - Symbol Definitions; Indicator Lights; Reset Mechanism

5-2
USER INTERFACE
Model C708 - WAWA
User Interface
5
Symbol Definitions
To better communicate in the international arena,
symbols have replaced words on many of our operator
switches, function, and fault indicators. Your Taylor
machine is designed with these international symbols.
The following chart identifies the symbol definitions.
= Select
= Up Arrow
= Down Arrow
= Auto
=Heat Cycle
= Wash
= Mix Low
= Mix Out
= Menu Display
= Mix Pump
= Standby
Power Switch
When placed in the ON position, the power switch allows
control panel operation.
Liquid Cyrstal Display (LCD)
The LCD is on the front control panel. During normal
operation the display is blank. The display is used to
show menu options and notifies the operator if a fault is
detected. On international models, the display indicates
the temperature of the mix in the hopper.
Indicator Lights
Mix Low—When the Mix Low key is illuminated, the
mix hopper has a low supply of mix and should be refilled
as soon as possible.
Mix Out—When the Mix Out key is illuminated, the
mix hopper has been almost completely exhausted and
has an insufficient supply of mix to operate the freezer. At
this time, the Auto mode is locked out and the freezer is
placed in the Standby mode. To initiate the refrigeration
system, add mix to the mix hopper and press the Auto
key
. The freezer will automatically begin operation.
Heat Mode—When the Heat mode key is illuminated,
the freezer is in the process of a Heat cycle. If enabled,
the Heat key can be pressed to start a Heat cycle. If
disabled, the Heat key is inoperable. By default, the
HEAT key is enabled.
BRUSH-CLEAN COUNTER—When the BRUSH CLEAN
COUNTER display has counted down to 1, the machine
must be disassembled and brush-cleaned within 24
hours.
Reset Mechanism
The RESET button is in the service panel on the left side
of the C708. The RESET button protects the beater
motor from overloading. Should an overload occur, the
reset mechanism will trip. To properly reset the freezer
place the power switch in the OFF position. Press the
RESET button firmly. Turn the power switch to the ON
position. Press the WASH key
and observe the
freezer's performance.
CAUTION! DO NOT use metal objects to press
the reset button. Failure to follow this instruction may
result in electrocution.