OPERATING PROCEDURES
6-5
Model C708 - WAWA
Operating Procedures
6
7. Slide the fork of the draw handle into the slot of the
draw valve. Secure with the pivot pin.
(See Figure 6-17.)
Figure 6-17
Note: The C708 features an adjustable draw handle to
provide portion control, giving a better, more consistent
quality to your product and controls costs.
The draw handle should be adjusted to provide a flow
rate of 5 oz. to 7-1/2 oz. (142 g to 213 g) of product by
weight per 10 seconds. To increase the flow rate, turn
the adjustment screw counterclockwise. Turn the
adjustment screw clockwise to decrease the flow rate.
8. Install the drip pans. (See Figure 6-18.)
Figure 6-18
9. Install the front drip tray and splash shield under the
door spout. (
See Figure 6-19.)
Figure 6-19
Mix Pump Assembly
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. Inspect the rubber and plastic pump parts. The
O-rings, check ring, and gasket must be in 100%
good condition for the pump and entire machine to
operate properly. They cannot properly serve their
intended function if nicks, cuts, or holes in the
material are present.
Inspect the plastic pump parts for cracks, wear, and
delamination of plastic. Replace any defective parts
immediately and discard the old.
2. Assemble the piston. Slide the O-ring into the groove
on the piston. Do not lubricate this O-ring.
(See Figure 6-20.)
Figure 6-20
To Next Page
Loading...
