USER INTERFACE
5-3
Model C708 - WAWA
User Interface
5
If the beater motor is turning properly, press the WASH
key
to cancel the cycle. Press the AUTO key to
resume normal operation. If the freezer shuts down
again, contact a Taylor service technician.
Mix Pump Reset Button
This reset button protects the pump from an overload
condition. Should an overload occur, the reset
mechanism will trip. To reset the pump, press the reset
button firmly.
CAUTION! DO NOT use metal objects to press
the reset button. Failure to follow this instruction may
result in electrocution.
Adjustable Draw Handle
This machine features an adjustable draw handle to
provide the best portion control, giving a better,
consistent quality to your product and controlling costs.
The draw handle should be adjusted to provide a flow
rate of 5 oz. to 7-1/2 oz. (142 g to 213 g) of product by
weight per 10 seconds. To increase the flow rate, turn
the screw counterclockwise. To decrease the flow rate,
turn the screw clockwise. (
See Figure 5-2.)
Figure 5-2
Operating Screen Descriptions
The LCD in the center of the control panel is normally
blank during the daily operation of the machine. The
display is activated when the Cone key or the Manager's
Menu is selected. The display screen will also alert the
operator of specific faults detected by the control.
Power Up Memory (Initializing)
When the machine is powered up, the control system will
initialize to perform a system check. The screen will
display INITIALIZING and check four types of data:
Language, System Data, Config Data, and Lockout Data.
An alarm will sound during the Language initialization. If
the language strings are not present or are corrupted, the
operator will be required to make a language selection.
System Data is checked next. If it is corrupted, the
machine will be set to OFF, the serving counters are set
to zero, and the faults are cleared. The “SYSTEM CRC
ERR” fault will display. Press the SEL key.
The Configuration Data is checked next. If it is corrupted,
all user and service settings are set to defaults. The
“CONFIG CRC ERR” fault will display.
Lockout Data is checked next. If the data is corrupted, all
lockout history data is cleared. The “LOCKOUT CRC
ERR” fault will display.
Once the system has initialized, the number of days until
the next required brush-cleaning is indicated on the
control panel. The SAFETY TIMEOUT screen will display
and the alarm will sound for 60 seconds or until any
control key is pressed.
After the safety time-out has completed and the power
switch is off, the following screen is displayed:
SAFETY TIMEOUT
ANY KEY ABORTS
POWER SWITCH OFF
- = - = - = - = - = -
UNIT CLEANED
To Next Page
Loading...
