6-10
OPERATING PROCEDURES
Model C708 - WAWA
Operating Procedures
6
11. Press the Wash and Pump keys and close
the draw valve. (See Figure 6-36.)
Figure 6-36
Important! The machine must not be placed in Auto
mode until all sanitizing solution has been removed
from the freezing cylinder and proper priming
procedures have been completed. Failure to follow
this instruction may result in damage to the freezing
cylinder.
Note: Make sure your hands are clean and sanitized
before continuing these instructions.
12. Remove the cotter pin from the pump. Stand the mix
feed tube in the corner of the mix hopper. Place the
cotter pin in position in the outlet fitting of the pump.
13. Place the agitator on the agitator driveshaft housing.
(
See Figure 6-37.)
Figure 6-37
Note: If the agitator should stop turning during normal
operation, with sanitized hands remove the agitator
from the agitator driveshaft housing and brush-clean with
sanitizing solution. Re-install the agitator back onto the
agitator driveshaft housing.
Priming
Note: Use only fresh mix when priming the freezer.
1. Place an empty pail beneath the door spout. Pour
2-1/2 gal. (9.5 L) of fresh mix into the mix hopper and
allow it to flow into the freezing cylinder.
2. Open the draw valve to remove all sanitizing solution.
When only fresh mix is flowing, close the draw valve.
Important! Failure to remove all sanitizing solution may
result in damage to the freezing cylinder.
Note: Make sure your hands are clean and sanitized
before performing the next step.
3. When the mix stops bubbling down into the freezing
cylinder, remove the cotter pin from the outlet fitting
of the mix pump. Insert the outlet end of the mix feed
tube into the mix inlet hole in the mix hopper. Place
the inlet end of the mix feed tube into the outlet fitting
of the mix pump. Secure with the cotter pin.
(See Figure 6-38.)
Figure 6-38
4. Select the AUTO key .
5. Fill the hopper with fresh mix and place the mix
hopper cover in position.
To Next Page
Loading...
