5-14
USER INTERFACE
Model C708 - WAWA
User Interface
5
Listed below are variable failure code messages which
could appear on line 2:
System Information
System information is displayed on four separate
screens. The first screen contains the control and
software version installed in the machine.
Press the SEL key to advance to the next system
information screen containing the software language
version.
Press the SEL key to advance to the next screen.
Press the SEL key to advance to the system information
screen containing the model’s bill of material and
machine serial number. Pressing the SEL key again will
return to the menu list.
HT HEAT TIME FAILURE
Mix temperature did not rise above 151°F
(66.1°C) in less than 90 minutes.
CL COOL MODE FAILURE
Mix temperature in the hopper and freezing
cylinder did not fall below 41°F (5°C) in less
than 90 minutes.
TT TOTAL TIME FAILURE
The Heat Treatment cycle must be completed
in no more than 4 hours.
ML MIX LOW FAILURE The heat phase or cool
phase time was exceeded and a Mix Low
condition was present.
MO MIX OUT FAILURE
A Mix Out condition was detected at the start
or during the Heat cycle.
BO BEATER OLVD IN HC
A beater overload occurred during the Heat
cycle.
PF POWER FAILURE IN HC
A power failure caused the heat phase, cool
phase, or Total Cycle Time to exceed the
maximum allowed time. If a power failure
occurs, but the Heat Treatment cycle does not
fail, an asterisk(*) will appear on the third line
of the display.
OP OPERATOR INTERRUPT
Indicates the Heat cycle was aborted in the
OPERATOR INTERRUPT option in the
Service Menu.
PS POWER SWITCH OFF
The power switch was placed into the OFF
position during the Heat cycle.
TH THERMISTOR FAILURE
A thermistor probe has failed.
PD PRODUCT DOOR OFF
A product door is not in place or is loose.
SOFTWARE VERSION
C708 CONTROL UVC4
VERSION X.XX
> Next
Language
V5.01 English
> Next
Bootloader
V1.13.000
> Next
B.O.M. C700000000
S/N M0000000
Othr= 00000
> Next
To Next Page
Loading...
