TB-Electronics F-SCAN COMPACT - Signal Amplitude Adjustment: Example; Setting Signal Amplitude (Example)

40 pages

To Next Page

To Previous Page

- 27 -

Example: how to change the amplitude from 80% to 75%:

1. Sw itch on

2. Select DEVICE SETTINGS

3. Confirm w ith CENTER

4. Confirm w ith CENTER

5. Set amplitude to 75%,

press KEY-DOWN 5 times.

6. Ter minate SET A MPLITUDE

NOTE: All user adjust ments to the default settings remain active until

either the user changes them again, or resets them as described on the

follow ing page.