57
Sustaining and Percussive Types
The Sustaining and Percussive Types hold fewer handles
than the Standard mode. Individually tuned these types
allow you two easily setup commonly used compression
styles.
Use the Sust
aining type to achieve the subtle
compression settings that will give you plenty of sustain
without “smashing” the sound too hard.
Use the Percussive type
to obtain the hard, obvious and
easy recognizable compression often achieved with
classic stomp box compressors
Though tuned differently the two types hold common
parameters.
Drive
Range: 1 to 20
A combination of Threshold and Ratio parameters that
sets the compression amount. Though auto make-up
gain is applied you may need to adjust the level slightly
using the Gain parameter when extreme settings are
used.
Response
Range: 1 to 10
Sets the time it takes for the Compressor to release the
compression. The lower setting the more you will hear
the compression.
Gain
Range: -12 to +12dB
Depending on the settings of Drive and Response
parameters you may need to adjust the Gain.
Enable
Range: Off/On
The effect’s status. All settings are stored as part of the
preset even if this particular effect is disabled.
EFFECTS – COMPRESSOR
To Next Page
Loading...
Need help?
General
