Pitch Shifter
The G-System’s Pitch Shifter gives you two voices, each
with a fixed pitch distance to the Input note. The
maximum range for this effect is +/- one octave. The
signal processing within the G-System happens so fast
that you will never notice any “searching” for notes as
with many older octaver units or octaver stomp boxes.
You might try lowering one voice to -1200 cents (100
Cent equal one semitone). At a Mix level of 100 (full
effect, no dry signal), you will be able to get at pretty
good bass simulation.
Voice 1
Range: -1200 to 1200 Cent
This parameter specifies the pitch of the first voice. As
100 Cent equal 1 semitone, you can select any interval
between one octave below the Input pitch to one octave
above it.
Voice 2
Range: -1200 to 1200 Cent
This parameter specifies the pitch of the second voice.
As 100 Cent equal 1 semitone, you can select any
interval between one octave below the Input pitch to one
octave above it.
Pan 1
Range: -50 to 50
This parameter sets the stereo position of the first voice.
Pan 2
Range: -50 to 50
This parameter sets the stereo position of the second
voice.
Delay 1
Range: 0 to 350ms
This parameter sets the Delay time for the first voice.
Delay 2
Range: 0 to 350ms
This parameter sets the Delay time for the second voice.
FB1
Range: 0 to 100%
This parameter determines how often the first voice will
be repeated by the Delay.
FB2
Range: 0 to 100%
This parameter determines how often the second voice
will be repeated by the Delay.
Mix
Range: 0 to 100%
This parameter sets the relationship between the dry
signal and the level of the effect in this Effect Block.
OutLev – Out Level
Range: -100 to 0dB
This parameter sets the overall Output level of this effect.
Enable
Range: Off/On
The effect’s status. All settings are stored as part of the
preset even if this particular effect is disabled.
EFFECTS – PITCH
65
To Next Page
Loading...
