13
CHAPTER 5: MODBUS TCP SETUP
5.1
View the IP and MAC Addresses
When the power supply is operating with the MODBUS TCP enabled, IP and MAC addresses may be viewed
on the front panel. To view the IP and MAC addresses, perform the following steps:
To view the IP address:
1. Press COMM button.
2. Rotate Voltage Encoder until IP appears on the Voltage display, 1 appears on the Current
display.
3. Press Current encoder to enter IP configuration. Rotate Voltage encoder to view the IP
address.
The voltage display shows IP1-IP4 by rotating Voltage encoder. The current display shows the
corresponding IP field
.
4. To exit the menu, press the COMM button or the BACK button.
To view the MAC address:
1. Press COMM button.
2. Rotate Voltage Encoder until MAC appears on the Voltage display, 1 appears on the Current
display.
3. Press Current encoder to enter MAC configuration. Rotate Voltage encoder to view the MAC
address.
The voltage display shows MAC1-MAC6 by rotating Voltage encoder. The current display shows
the
corresponding MAC field.
4. To exit the menu, press the COMM button or the BACK button.
5.2
Change the IP Address
The power supply allows changing all four numbers (octets) of the IP address via the front panel.
The IP address has four numbers (i.e. 10.97.4.4). Each number may be set to any value from 0 to 255.
NOTE
Some restrictions may apply due to subnet settings restrictions.
To Next Page
Loading...
