2
C. Full remote programming and monitoring functions
• Uses MODBUS TCP command language.
• Compatible with MODBUS TCP test & measurement utilities.
• TCP sockets which support PLCs, Linux and other non-VISA controllers.
• Multiple and simultaneous (up to 4) sockets connections are allowed by port 502.
D. Front Panel features
• View IP and MAC addresses.
• Set a complete IP address.
• MODBUS TCP (OPT) reset.
• Remote “Blink” identity function to locate the power supply in a rack.
E. Rear Panel features (2-Port MODBUS TCP)
• Two Ethernet RJ-45 connectors (standard 8 pin jack).
• Allow connection of multiple MODBUS TCP power supplies directly.
• Each power supply receives its own IP address.
• Network status, module status and two ports link/activity indicators.
F. RS-485 Multi-drop Chain
• Allow connection of up to 31 power supplies using a simple link cable.
• One MODBUS TCP IP address shared by all RS-485 power supplies.
NOTE
Only one of the two Ethernet RJ-45 connectors should be connected to a master PC/PLC.
To Next Page
Loading...
