40
WARNING:
Terminals 7, 9 and 12 of J1 are connected internally to the negative sense(-S) potential of the power
supply. Do not attempt to bias any of these terminals relative to the negative sense. Use the Isolated
Programming interface option to allow control from a programming source at a different potential
relative to the power supply negative.
CAUTION:
To prevent ground loops and to maintain the isolation of the power supply when programming from
J1, use an ungrounded programming source.
WARNING:
There is a potential shock hazard at the output when using a power supply with rated output greater
than 70V. Use wires with minimum insulation rating equivalent to the maximum output voltage of
the power supply.
WARNUNG:
Beim Einsatz eines Netzteils mit einer Nenn-Ausgangsspannung von mehr als 70V besteht
Stromschlaggefahr am Ausgang. Es sind Drähte mit minimalem Isolierwert zu verwenden, welcher
der maximalen Ausgangsspannung des Netzgerätes entspricht.
To Next Page
Loading...
