TDK-Lambda Z10-20 - Page 87

86
*RCL n
Restores the power supply to a state previously stored in memory by *SAV command. Refer to
Table 5-9.
Meaning and Type Recall Device State
Command Syntax *RCL <NR1>
Parameters 1 to 4
Query Commands *RCL 3
Query Syntax None
*RST
This command resets the power supply to a defined state as shown in Table 5-9. *RST also forces
an ABORt command.
Meaning and Type Recall Device State
Command Syntax *RST
Parameters None
Example None
*SAV n
The SAV command saves all applied configuration setting. Refer to Table 5-9.
Command Syntax *SAV <NRf>
Parameters 1 to 4
Query Syntax None
*SRE
Service Request Enable command. Modifies the contents of the Service Request Enable Register.
Meaning and Type Service Request Enable Device Interface
Command Syntax *SRE <NRf>
Parameters 0 to 255
Default Value See *PSC
Example *SRE 20
Query Syntax *SRE?
Returned Parameters <NR1> (Register binary value) 3digits