6. OUTLINE OF PREPARATION PROCEDURE BEFORE OPERATING THE ECR EO1-11154
6.1 Installing/Replacing the Receipt/Journal Roll
6- 4
5. Fully close the receipt cover until it clicks.
6. Press and hold the [RF] key for a few sconds and
make sure that the the receipt paper is fed correctly.
If it is not fed correctly, start from Step 1 again.
7. Press the [C] key to cancel the error status. Then
the status shown in the figure is displayed.
8. Manually cut the receipt paper which was fed.
Recei
t Cove
RF
Current time is displayed here.
To Next Page
Loading...
