Chapter 13 Preventive maintenance
This chapter describes the maintenance the operator is responsible for.
In This Chapter
Maintenance safety 47
Maintenance schedule 47
Maintenance safety
You are not allowed to calibrate or adjust the test lane. Only trained service engineers are
allowed to calibrate or adjust.
Shut down the test lane before you perform any maintenance on the test lane.
Danger
Remove or switch off the fuses from the main electrical supply before you start the
maintenance.
Maintenance schedule
Most of the parts of the test lane are free of any maintenance. The bearings and gear boxes
are greased for life.
47
PART ACTION
During operation
Test lane Verify that there are no abnormal noises and other unusual signs during
operation.
Daily
Test lane Before you start the test, verify if the safety limit switches at the slippage
detection rollers function correctly: Turn the slippage detection roller. The
lights of the proximity switches light up.
Weekly
Test lane Clean the parts of the test lane.
Keep the test lane clean and dust free.
Clean the sheet metal with a lukewarm soap solution.
Caution
Do not use aggressive or abrasive detergents.
Do not use a high pressure cleaner.
Every three months
Transmission chains
roller brake tester
Verify that the chains are in good condition. Check for wear.
Grease the chains:
Open the center cover of the roller
brake tester.
Grease the chains with a chain
lubricant. Use a lubricant like Iwis VP6
Kombi Superplus or comparable.
To Next Page
Loading...