tecan Columbus Washer - Show Program

5. Programming Procedure
5.4 Show Program
This submenu is used to display the parameters that have been defined for a
program.
The displayed parameter settings can not be altered in this submenu.
Selected
p
late t
yp
e dis
p
la
y
ed
Selected manifold type displayed
Selected dis
p
ensin
g
s
p
eed
(
1 - 5 or dri
p)
Printing......
Parameters being printed
Plate Type: X
exit yes
Manifold Type:XX
exit yes
Disp Rate: X
exit yes
Asp Rate: X
exit yes
Crosswise: XX
exit yes
Selected aspirating speed
(1 - 5
[
8 or 12 way manifold
]
or 1 - 3 (16 way manifold or 384 Well
Manifold)
The speed of the aspirating pump.
Selected setting for crosswise aspiration
Plate type
Flat bottomed
Plate type
Round bottomed
Selected o
p
eratin
g
mode
(strip or plate)
Select re
q
uired
p
rocess ste
p
to be shown
usin
g
-
and
+
ke
y
s or
p
ress
y
es
to ste
p
through all steps and settings
C:1 P:1 XXXX
- + Exit yes
Mode: Xxxxxx
exit yes
Sel. Strips: XXX
exit yes
Selected setting for strip selection
The speed of the dispensing pump.
If printer option fitted, select if
parameters are to be selected or not.
Show XX:yyyyyyy
- + other yes
Select required program to be
shown
Print List now ?
YES NO
Show XX:yyyyyyy
- + other yes
May 2003 Instructions for Use for Columbus Washer No. I 109 006 Rev No. 2.2 5-7