8. Trouble Shooting
8. Trouble Shooting
8.1 Introduction
Error Description Possible Causes See
Chapter
Incorrect Plate
Position
Plate parameters are not defined
(Adjust Menu)
6
Program not defined No test defined in the instrument memory 5
Program too Big If more than 60 process steps have been
defined
5
Wrong Manifold Manifold not correctly defined in Adjust Menu 6
Display and LED
dark
Defective fuse 7.2
No or incorrect
dispensing
Dispensing needles blocked 7
No or incorrect
aspirating
Aspirating needles blocked 7
Manifold Arm Error The manifold arm does not move up and down 3
May 2003 Instructions for Use for Columbus Washer No. I 109 006 Rev No. 2.2 8-1
To Next Page
