32
Device only triggers alarm when it detects any motion in armed time. User can set schedule
time to be “all the time”, also assign the armed time. Before you set “Time Schedule”,
please go to Date and Time settings to set the correct time
Figure 8-13
After enabling Motion Detect Armed you can see the following options.
Motion Detect
Sensibility
Set the sensibility fro 1 to 10 (The smaller the value, the
more sensitivity.)
Alarm Audio
Sensibility
Choose to get alarmed if noise is detected (low, medium,
high or forbid).
Infrared alarm
Check the box to activate the PIR sensor
Alarm Input Armed
(not supported)
Check the box for external alarm
Trigger Level
(not supported)
Set up an external alarm input low or high
Alarm Preset Linkage
(not supported)
Choose a preset here. When motion is detected the
camera will go to the selected preset position.
I/O Linkage on Alarm
(not supported)
Check the box for exporting control alarm signal
To Next Page
Loading...
Need help?
General
Weight and Dimensions
