Technics RS-TR575M2

Recording
Use [REC LEVEL] to adjust the recording
level.
(+ Page 14.)
Stop play of the source.
Press [ ◄ ] or [ ► J to begin recording, and play
the source to be recorded.
► : Forward side.
4: Reverse side.
IWI
When recording on both sides of the tape, be sure to press
[ ► ] •
Press the corresponding buttons for DECK 2 to record
on that deck.
To stop recording
Press [ ■ ].
To temporarily stop recording
Press [ II PAUSE],
The “PLAY” indicator will flash.
Press once again to resume recording.
To cancel the ATC settings
[While ATC settings are in progress]
Press [ ■ ].
[After ATC settings have been completed)
Press [ATC].
If the “M” indicator begins to flash quickly while the
ATC settings are in progress
It indicates that the settings cannot be made for one of the following
reasons.
• The tape has reached the leader tape.
• The tape is severely damaged.
• The cassette deck’s heads are severely dirty.
• The tape is a non-standard type, such as a metal tape which has
no tape type identification hole in the cassette.
IMISI
• If the cassette holder is opened after the ATC settings have been
completed, the settings will be cancelled.
• If the ATC settings are to be made midway through a tape, leave
a two second interval after the track prior to where ATC is to
begin.
For your reference
[BALANCE] should normally be set to the center position.