Technics SA-DX930

A SPEAKERS B
L— SETTING —
a
ee,
| go
aaa
TAPE TAPE MONITOR
(MONITOR) C)
A SPEAKERS B
-SPEAKERS =
O (iow)
TAPE MONITOR
t |
| Basic operations
For front speakers with an impedance under 8 Q EI
Press and hold [A] or [B] until “LOW IMP" lights
up on the display.
If even one of the speakers being used has an impedance under
8 Q, press and hold down either [A] or [B] for 4 seconds or more to
set the impedance on the main unit to LOW.
(Press and hold down once again for 4 seconds or more to turn it
off.)
Note that when "LOW IMP” is illuminated, speakers A and B
cannot both be used at the same time.
To change a speaker:
e.g. To use speaker B, press [A] ( “i” goes out), and then press
[B] to activate speaker B.
The TAPE (MONITOR) indicator
This indicator lights in the following two situations:
1. While TAPE is selected.
2. While TAPE MONITOR is in use.
To use the tape monitor El
if [TAPE MONITOR] is pressed while a source other than
TAPE is selected, the “TAPE (MONITOR)' indicator lights and the
tape monitor comes on. ]
Sources other than tape can still be selected with [INPUT
SELECTOR] while the “TAPE (MONITOR)' indicator is on.
Press (TAPE MONITOR] again to turn the tape monitor off.
(™ See "Making a recording" on page 32 for details on how to use
the tape monitor during recording.)
€ The tape monitor cannot be used when TV/DSS, DVD, or CD
digital input is being used.
è |f you are using the tape monitor and you select a digital input
source, the tape monitor switches off.
tions
ic opera
fil Bas
RQT4918